Hard Disk Spindle Motor
The spindle motor, also sometimes called the spindle shaft, is responsible for turning the hard disk platters, allowing the hard drive to operate. The spindle motor is sort of a “work horse” of the hard disk. It’s not flashy, but it must provide stable, reliable and consistent turning power for thousands of hours of often continuous use, to allow the hard disk to function properly. In fact, many drive failures which result in the need for hard drive data recovery, are actually failures with the spindle motor, not the data storage systems.
A hard disk spindle motor, stripped of its platters and other components, and detached
from the drive’s base casting. You can see that it attaches with three screws around its
perimeter. The shiny metal is the shaft, which rotates; the dull metal is the base of the motor.
The six small screw holes on the top of the shaft are for securing the platters. You can also see
a large screw hole in the center top of the shaft, which is used to attach the top cover to the
spindle shaft for added stability. the four wire connector attaches to the hard disk logic board.
For many years hard disks all spun at the same speed. In the interests of performance, manufacturers have been steadily ratcheting up their products’ spin speeds over the last few years. These higher-speed spindles often have issues related to the amount of heat and vibration they generate. The increased performance and also the new potential issues related to the spindle motor have given it renewed attention in the last few years.
